Eragrostis curvula (Schrad.) Nees var. curvula

Scientific Name: Eragrostis curvula (Schrad.) Nees var. curvula

Eragrostis curvula (Schrad.) Nees var. curvula

General Information
Usda Symbol	ERCUC4
Group	Monocot
Life Cycle	Perennial
Growth Habits	Graminoid
Native Locations	ERCUC4

Plant Guide

Use soil moisture sensors to measure the soil moisture of Eragrostis curvula (Schrad.) Nees var. curvula.

Fact Sheet

Uses

Erosion control: Weeping lovegrass is used as a temporary cover for erosion control purposes, On surface mine spoil, it provides almost immediate cover on steep outer slopes where spoil is rather acidic and of low fertility, Use soil moisture sensors to measure the soil moisture of Eragrostis curvula (Schrad.) Nees var. curvula., Crops: Weeping lovegrass is used as a nurse crop when seeding sericea lespedeza, coastal panic grass, or switchgrass, When seeding black locust or bristly locust, it serves as a companion species,

Status

Please consult the PLANTS Web site and your State Department of Natural Resources for this plant’s current status (e.g. threatened or endangered species, state noxious status, and wetland indicator values).

Description

Eragrostis curvula (Schrad.) Nees, weeping lovegrass, is a rapidly growing warm-season bunchgrass that was introduced into the U. S. from East Africa. The many long, narrow leaves emerging from a tight tuft are pendulous, with the tips almost touching the ground. The drooping leaf characteristic gives rise to the name “weeping” lovegrass. Leaf height is rarely above 12 inches. The seed heads are open panicles, reaching a height of 30 to 40 inches and containing numerous small, fine seeds.

Adaptation

Weeping lovegrass prefers a light-textured, well-drained soil, and will thrive on soils of low fertility. Climatic conditions determine its range of adaptation. Low winter temperatures will prevent regrowth and cause the grass to act as an annual or a short-lived perennial. Weeping lovegrass is distributed throughout the southern United States. For a current distribution map, please consult the Plant Profile page for this species on the PLANTS Website.

Establishment

This grass is easy to establish by seed. Seed alone at a rate of 3 to 5 pounds per acre, or 1 to 2 pounds per acre in mixtures with other species. Seeds will germinate quickly and plant growth is rapid. The seed is extremely fine, requiring mechanical seeding equipment to have small seed attachments. If seeded with a ‘hand’ cyclone seeder, the lovegrass seed should be mixed with a diluent or a carrier (cornmeal, sand, or fine sawdust) for uniform distribution of seed. Do not cover seed more than 1/2 to 1 inch on sandy soils; 1/4 inch is sufficient on silt loams. Cultipacking soil before seeding is helpful. USDA NRCS National Plant Materials Center Beltsville, MD Sites too steep or stony for use of mechanical equipment can be seeded without soil scarification. Broadcast seeding by air or use of hydroseeders is successful if seeding rates are increased to compensate for poor seedbed. Where possible, the soil should be scarified and firmed. Normally, weeping lovegrass can be planted after danger of severe frost is over, and anytime throughout the summer with success. Lime and fertilizer needs are similar to that for tall fescue and ryegrass when used for temporary cover.

Management

Because of its short duration, there is no management required for weeping lovegrass. It is palatable to livestock and should be protected where this possibility exists.

Plant Traits

Growth Requirements

Morphology/Physiology

Reproduction

Suitability/Use

Eragrostis curvula (Schrad.) Nees var. curvula

Eragrostis curvula (Schrad.) Nees var. curvula

Eragrostis curvula (Schrad.) Nees var. curvula

Eragrostis curvula (Schrad.) Nees var. curvula

Eragrostis curvula (Schrad.) Nees var. curvula

Eragrostis curvula (Schrad.) Nees var. curvula

Eragrostis curvula (Schrad.) Nees var. curvula

Eragrostis curvula (Schrad.) Nees var. curvula